Pressure Washer Pull Cord Will Not Start

The end result is a carburetor that does not work and a pressure washer that does not start.

Pressure washer pull cord will not start.

If the pressure washer does not start on that first pull you will be adding more and more with each pull. Remove the spark plug and then pull the starter rope to see if the engine spins. If the starter rope won t budge when you try to pull it the engine may be locked up or the recoil starter may have failed. Pressure washer pull cord locked up honda gcv160 won t pull stuck.

The carburetor might be clogged. Flushing the carburetor out with a special cleaning agent should remove the residue and allow the power washer to start. Took a look at the pull rope assembly to see what was jammed or bent or broken. Over time some of the ingredients in the fuel may evapo rate leaving behind a thicker stickier substance.

This pressure washer had a stuck pull rope. This sticky fuel can clog up the carburetor and prevent the engine from starting. If you tipped the pressure washer on its side recently oil may have filled the cylinder preventing the engine from spinning. After that with each consecutive pull it will be even harder and soon enough the cord will break under the pressure.

Honda power washer when you shut down your presure washer the pump makes pressure before y. When a pressure washer pull cord snaps on a job it is a real pain. No ned to panic this short video by paul crosbie at spinaclean will show you how to save.