Roof Anchor Points Legislation

Anchor points anchor points are a vital part of a fall protection system.

Roof anchor points legislation.

In order to comply with safety legislation it is important that when an individual is working at heights specific control measures are used. Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling. Roof anchor points may not be as exciting as a day out on the boat but they can be the one piece of equipment that ensures that you can get home to family safety at the end of a work day. The only exemption to this is for concrete mounted if they have been cast in.

Only certified roof anchor point installers should be used for the certification of roof anchor points. Most roof anchors only require a visual inspection. For a 15kn rated anchor points that is 7 5kn. This fact sheet provides advice on fall arrest anchors and was updated august 2019.

Whs regulations require roof anchor points in nsw to be annually certified to ensure they are in good working order. It includes information about as 1891 4. Selection use and maintenance and as nzs 5532 2013 manufacturing requirements for single point anchor devices used for harness based work at height under the work health and safety whs legislation. However glue in and friction type usually installed in concrete must be load tested to 50 of their nominated capacity for 3 minutes.

Upon completion of the inspection process a certificate of compliance valid for 12 months will be issued. 2009 industrial fall arrest systems and devices part 4.